Command Reference Guide

318 ● voip call-start 3Com Router 5000 Family and Router 6000 Family
Command Reference
voip call-start
Purpose Use the voip call-start command to configure a call initialization mode for the
called GW.
Use the undo voip call-start command to restore the default.
Syntax voip call-start { fast | normal }
undo voip call-start
Parameters fast
The called GW initializes calls in a fast way.
normal
The called GW initializes calls in a non-fast way.
Default By default, the fast mode is used.
Example Configure the called gateway to initialize calls in normal mode.
[Router-voice] voip call-start normal
View This command can be used in the following views:
■ Voice view
Description As the process of faculty negotiation is omitted in fast connect procedures, the
faculties of the two parties are determined by the GW. If a router acts as a calling GW,
you can enable or disable fast connect for each channel of initiated calls. If it acts as a
called GW, it will use or not use the fast connect mode to initialize calls depending on
the parameters of the
voip call-start command, in the case that the calling
GW uses the fast connect mode.
Related Command fast-connect