Command Reference Guide

3Com Router 5000 Family and Router 6000 Family vi-card cptone-custom ● 309
Command Reference
vi-card cptone-custom
Purpose Use the vi-card cptone-custom command to set the prompt tone parameters
of the system.
Use the undo vi-card cptone-custom command to delete the prompt tone
parameters.
Syntax vi-card cptone-custom type arg0 arg1 arg2 arg3 arg4 arg5 arg6
undo vi-card cptone-custom { type | all }
Parameters Type
Prompt tone type, currently supporting the following
types: dial-tone, special-dial-tone, busy-tone,
congestion tone, ringback-tone, and waiting-tone.
arg0
Combination mode, in the range of 0 to 2. 0 indicates
the overlapping of the two frequencies; 1 indicates the
modulation of the two frequencies; 2 indicates the
alternation of the two frequencies.
arg1/arg2
Frequencies of the two single-frequency tones in Hz.
The range of the two frequencies is related to the
combination mode (arg0). If the mode is overlapping
or alternation, the range of the two frequencies is 300
to 3400; if the mode is multiplication, the range of the
two frequencies is 0 to 3400 and the absolute value of
the two frequencies’ sum and difference must be in
the range of 300-3400.
arg3
The on duration of the first on-off ratio in ms, in the
range of 30 to 8191. If the prompt tone is played
continually, the value is set to 8192.
arg4
The off duration of the first on-off ratio in ms, in the
range of 30 to 8191.
arg5
The on duration of the second on-off ratio in ms, in
the range of 30 to 8191.
arg6
The off duration of the second on-off ratio in ms, in
the range of 30 to 8191.
all
All types of prompt tones.
Table 1 Type of prompt tone
Type of prompt tone Description
dial-tone Dial tone
special-dial-tone Special dial tone
congestion-tone Congestion tone
busy-tone Busy tone
ringback-tone Ringback-tone
waiting-tone Waiting tone