Command Reference Guide

300 ● ts 3Com Router 5000 Family and Router 6000 Family
Command Reference
ts
Purpose Use the ts command to maintain the trunk circuit of the specified timeslot.
Syntax ts { block | open | query | reset } timeslots timeslots-list
Parameters block
Indicate blocking the trunk circuit of the specified
timeslot.
open
Indicate opening the trunk circuit of the specified
timeslot.
query
Indicate querying the trunk circuit of the specified
timeslot.
reset
Indicate resetting the trunk circuit of the specified
timeslot.
timeslots timeslots-list
Specify a timeslot range. The expression includes the
single digit, two digits separated by “,”, a pair of digits
separated by “-”, or the combination form (e.g., 1-14,
15, 17-31). The value range of digits is the integer
from 1 to 31.
Example Reset the circuit of timeslots 1-15 in No.5 Timeslot set and query the status of the
circuit of timeslots 1-31.
[Router-cas1/0/0:5] ts reset timeslots 1-15
[Router-cas1/0/0:5] ts query timeslots 1-31
View This command can be used in the following views:
■ R2 CAS view
Description Use the ts command to maintain the trunk circuit of the specified timeslot.
This command applies to E1 voice only.
To block the trunk circuit means that the circuit no longer loads the service
information, that is, this circuit is set manually as unavailable.
To open the trunk circuit is the inverse process of the blocking operation, which can
reset the trunk circuit as available and enable it to load service information.
To query the trunk circuit will display the busy/idle, opened/blocked status of the
circuit in a real time way.
To reset the trunk circuit refers to re-initializing the state of trunk circuit. Generally, if
the circuit state cannot be restored to normal in blocking or opening the circuit
manually, it is required to perform the resetting. If the circuit cannot be reset