Command Reference Guide

3Com Router 5000 Family and Router 6000 Family timer ring (R2) ● 289
Command Reference
timer ring (R2)
Purpose Use the timer ring command to configure the maximum time range before the
signal tone of R2 signaling is sent.
Use the
undo timer ring command to restore it to the default value.
This command applies to E1 voice only.
Syntax timer ring { ringback | ringbusy } time
undo timer ring { ringback | ringbusy }
Parameters ringback time
Time interval before ring-back tone is sent, ranging
from 1,000 to 90,000ms. By default, it is set to
60,000ms.
ringbusy time
Time interval before busy tone is sent, ranging from
1,000 to 90,000ms. By default, it is set to 30,000ms.
Example Configure the timeout interval for R2 signaling ring-back tone to 10,000ms.
[Router-cas1/0/0:0] timer ring ringback 10000
View This command can be used in the following views:
■ R2 CAS view
Description By manually configuring the senrding command, you can enable the device at the
originating point to send ring-back and busy tones to the calling party. The
timer
ring
command helps you identify these signals.
Related Command sendring