Command Reference Guide

3Com Router 5000 Family and Router 6000 Family timer dtmf (R2) ● 285
Command Reference
timer dtmf (R2)
Purpose Use the timer dtmf command to configure the time interval for sending DTMF
signals.
Use the undo timer dtmf command to restore the default value.
Syntax timer dtmf time
undo timer dtmf
Parameters time
Interval at which R2 signaling sends DTMF signals, in
the range 50 to 10000 milliseconds. It defaults to 50
milliseconds.
Example Configure the R2 signaling to send a DTMF signal 800 milliseconds after the reception
of the seizure acknowledgement signal.
[3Com -cas1/0/0:0] timer dtmf 800
View This command can be used in the following views:
■ R2 CAS view
Description This command applies to E1 voice only.
Normally, the originating point sends a DTMF signal upon receiving the line seizure
acknowledgement signal. Using this command, you can configure the device at the
originating point to send a DTMF signal after the specified time interval, so as to
make it appropriate to the number receiving process of the peer PBX,
Related Command dtmf