Command Reference Guide

282 ● timer (Digital E&M) 3Com Router 5000 Family and Router 6000 Family
Command Reference
timer (Digital E&M)
Purpose Use the timer command to configure the timeout values of the signals in the digital
E&M signaling.
Use undo timer command to restore them to defaults.
Syntax timer { dial-interval | ring-back } seconds
timer wait-digit { seconds | infinity }
undo timer { dial-interval | ring-back | wait-digit }
Parameters dial-interval seconds
Set the max waiting time between two digit numbers,
it is any integer in the 0 to 300 seconds. By default, the
dial-interval seconds is 4 seconds.
ring-back seconds
Set the timeout time for the calling party to wait for
the ringback response from the called party. It is any
integer in the range 5 to 60000 seconds. By default,
the ring-back seconds is 60 seconds.
wait-digits second
Set the timeout time for the called party to wait for the
called number. It is any integer in the range 3 to 600
seconds. By default, the wait-digits seconds is 5
seconds.
infinity
Indicate that there is no time limit, that is, timeout will
not occur.
Example Set the ringback response timer to 30 seconds on a voice subscriber-line.
[Router-voice-line1/0/0:3] timer ring-back 30
View This command can be used in the following views:
■ Digital E&M Voice Subscriber-Line view
Description This command applies to E1 voice only.
The timer ring-back seconds command can be used at the digital E&M
subscriber-line to set the timeout time for a calling party to wait for the ringback
response from the called party.
The timer wait-digit seconds command can be used at the digital E&M
subscriber-line to set the timeout time for a called party to wait for the called number.