Command Reference Guide

272 ● subscriber-line 3Com Router 5000 Family and Router 6000 Family
Command Reference
subscriber-line
Purpose Use the subscriber-line command to enter the voice subscriber-line view.
Syntax subscriber-line slot-number: { ts-set-number | 15 }
subscriber-line slot-number: 23
Parameters slot-number
Indicate the subscriber line number generated in
creating Timeslot set or ISDN PRI set, determined by
the slot number of the E1V1 module.
ts-set-number
Indicate the number of Timeslot set created
successfully.
15
Indicate the subscriber line is generated in creating the
ISDN PRI set on E1 subscriber line.
23
Indicate the subscriber line is generated in creating the
ISDN PRI set on T1 subscriber line.
Example Enter the view of subscriber line 1/0/0:5.
[Router-voice] subscriber-line 1/0/0:5
R2 interface encountered
[Router-voice-line1/0/0:5]
View This command can be used in the following views:
■ Voice view
Description This command applies to E1 and T1 voice.
After creating the Timeslot set successfully, the system will generate the subscriber
line corresponding to this Timeslot set according to current E1 subscriber-line number
and Timeslot set number, and the subscriber line number is “E1 subscriber-line
number: Timeslot set number”.
After configuring the ISDN PRI set successfully, the system will generate the subscriber
line corresponding to this PRI set according to the number of E1 subscriber-line where
the current PRI subscriber-line is located, and the subscriber line number is “E1
subscriber-line number: 15”.
After configuring the ISDN PRI set successfully on T1 subscriber-line, the system will
generate the subscriber line corresponding to this PRI set according to the number of
T1 subscriber-line where the current PRI subscriber-line is located, and the subscriber
line number is “T1 subscriber-line number: 23”.