Command Reference Guide

3Com Router 5000 Family and Router 6000 Family special-character ● 269
Command Reference
special-character
Purpose Use the special-character command to configure the supported special
characters during register signal exchange.
Syntax special-character character number
Parameters character
A special character, which can be #, *, A, B, C, or D.
number
Code of the register signal, ranging from 11 to 15.
Default By default, no special character is configured.
Example Configure register signal code of # to 11.
[3Com -cas1/0/0:0] special-character # 11
View This command can be used in the following views:
■ R2 CAS view
Description This command applies to E1 voice only.
In some countries, besides numerical information, register forward Group I signal of
R2 signaling also supports the information containing special characters, such as #
and *. To encode these special characters, you need to use the
special-character command.
■ Do not use the special-character command to configure one special
character to different signal codes.
■ Up to six special characters can be configured with register signal codes.
■ Different special characters must use different signaling values; otherwise, calling
may be affected.