Command Reference Guide

268 ● source-ip 3Com Router 5000 Family and Router 6000 Family
Command Reference
source-ip
Purpose Use the source-ip command to bind a source IP address to the gateway when it
functions as a User Agent (UA).
Syntax source-ip ip-address
undo source-ip
Parameters ip-address
IPv4 address.
Default By default, no SIP source IP address is configured.
Example Set the local source address to 1.1.1.1.
[Router-voice-sip] source-ip 1.1.1.1
View This command can be used in the following views:
■ SIP Client view
Description You can use this command however only when the register-enable off
command is configured.
Note that this source address should be the IP address of an existing interface on the
gateway.