Command Reference Guide
254 ● send-number (in Voice Subscriber-Line View) 3Com Router 5000 Family and Router 6000 Family
Command Reference
send-number (in Voice Subscriber-Line View)
Purpose Use the send-number command to configure the FXS voice subscriber-line to allow
the FXS to send called numbers.
Use the undo send-number command to disable the FXS to send called numbers.
Syntax send-number
undo send-number
Parameters None
Default By default, the FXS is disabled to send called numbers.
Example Enable the FXS to send called numbers on FXS voice subscriber-line 0/0/0.
[Router-voice-line0/0/0] send-number
View This command can be used in the following views:
■ FXS Voice Subscriber-Line View
Description Normally, the FXS interface is connected to a standard telephone, so the FXS does not
need to send called numbers. But sometimes, the FXS interface is connected to the
FXO interface. In this case, when the FXO receives a ring from the FXS, it imitates an
off-hook and sends dial tone for the second stage of dial. With the send-number
feature enabled, the FXS voice subscriber-line can send called numbers to the
connected FXO interface directly to free the calling party from the second stage of
dial.