Command Reference Guide

3Com Router 5000 Family and Router 6000 Family send-number (in Voice Entity View) ● 253
Command Reference
send-number (in Voice Entity View)
Purpose Use the send-number command to configure the number sending mode.
Use the undo send-number command to restore the default mode.
Syntax send-number { digit-number | all | truncate }
undo send-number
Parameters digit-number
Number of least significant digits that are sent. Valid
values are 0 to 31. It is not larger than the total
number of digits of the called number.
all
All digits of the called number.
truncate
Send the truncated called number.
Default By default, the truncate mode is used.
Example Configure voice entity 10 to send the 6 least significant digits of the called number.
[3Com -voice-dial-entity10] send-number 6
View This command can be used in the following views:
■ POTS Voice Entity view
Description This command only applies to POTS voice entities. As for the numbers sent to PSTN,
this command is used to control how to send the called numbers. You can not only
configure to send some digits (defined by
digit-number from right to left) or all
digits of the called number, but also the truncated called numbers, i.e., the numbers
that match the wildcard “.” at the end.
Related Commands ■ dot-match
■ match-template