Command Reference Guide

242 ● seizure-ack 3Com Router 5000 Family and Router 6000 Family
Command Reference
seizure-ack
Purpose Use the seizure-ack command to enable or disable the terminating point to send
seizure acknowledgement signal.
Syntax seizure-ack { enable | disable }
Parameters enable
Enables the terminating point to send seizure
acknowledgement signal.
disable
Disables the terminating point to send seizure
acknowledgement signal.
Default By default, the terminating point sends seizure acknowledgement signal.
Example Disable the terminating point to send seizure acknowledgement signal.
[3Com -cas1/0/0:0] seizure-ack disable
View This command can be used in the following views:
■ R2 CAS view
Description This command applies to E1 voice only.
Normally, the terminating point sends seizure acknowledgement signal when it
receives a seizure signal from the originating point. However, in some countries R2
signaling encoding scheme allows the terminating point not to send seizure
acknowledgement signal. In this case, you can use the
seizure-ack command to
adjust the signaling encoding scheme. If the originating point does not require
acknowledgement signal, the terminating point has no need to send back the signal
when it receives a seizure signal.
Related Command timer dl seizure