Command Reference Guide

3Com Router 5000 Family and Router 6000 Family rule ● 241
Command Reference
■ Discards (the digits corresponding to) the extra dots in input-number. When
you use the
dot-match command to configure the dot match rule as right-left
(from right to left) or left-right (from left to right), and the number of dot digits in
input-number are greater than or equal to that in output-number, two cases
exist:
Case 1: For right-left matching, extract from right to left the digits corresponding to
the dots in
input-number and use them to replace the dots in output-number
one by one. The digits corresponding to dots that are not extracted in
input-number are discarded.
Case 2: For left-right matching, extract from left to right the digits corresponding to
the dots in
input-number and use them to replace the dots in output-number
one by one. The digits corresponding to dots that are not extracted in
input-number
are discarded.
Default By default, no number-substitute rules are configured.
Example Configure the number-substitute rules for number-substitute list 1
[3Com -voice-dial-substitute1] rule 1 ^91 1
[3Com -voice-dial-substitute1] rule 2 ^92 2
[3Com -voice-dial-substitute1] rule 3 ^93 3
View This command can be used in the following views:V
■ Voice Number-Substitute view
Description When you have successfully created a number-substitute list, you need to use the
command to configure the number-substitute rules in it.
Related Commands ■ substitute
■ number-substitute
■ first-rule
■ dot-match