Command Reference Guide

3Com Router 5000 Family and Router 6000 Family register-value ● 223
Command Reference
Specifies request current digit value. Valid values are 1
to 16.
If no value is specified, the default is 16.
req-firstcallingnum value
Specifies request first calling number value. Valid
values are 1 to 16.
If no value is specified, the default is 5.
req-firstdigit value
Specifies request first digit value. Valid values are 1 to
16.
If no value is specified, the default is 16.
req-nextcallednum value
Specifies request next called number value. Valid
values are1 to 16.
If no value is specified, the default is 1.
req-nextcallingnum value
Specifies request next calling number value. Valid
values are1 to 16. It defaults to 5.
req-lastfirstdigit value
Specifies request last first digit value. Valid values are1
to 16.
If no value is specified, the default is 2.
req-lastseconddigit value
Specifies request last second digit value. Valid values
aree 1 to 16.
If no value is specified, the default is 7.
req-lastthirddigit value
Specifies request last third digit value. Valid values are1
to 16.
If no value is specified, the default is 8.
req-switch-groupb value
Specifies request switch Group-B value. Valid values
arerange 1 to 16.
If no value is specified, the default is 3.
subscriber-busy value
Specifies subscriber line busy value. Valid values are 1
to 16.
If no value is specified, the default is 3.
subscriber-idle value
Specifies subscriber line idle value. Valid values are 1 to
16.
If no value is specified, the default is 6.
Example Request the originating point to send calling category by configuring a backward
signal (signal value 7).
[3Com -cas1/0/0:0] register-value req-callingcategory 7
View This command can be used in the following views:
■ R2 CAS view
Description Signal value 16 means the corresponding signal function does not exist. For example,
if the request last first digit function does not exist in some countries, the value of
req-lastfirstdigit is 16.
This command applies to E1 voice only.