Command Reference Guide

222 ● register-value 3Com Router 5000 Family and Router 6000 Family
Command Reference
register-value
Purpose Use the register-value command to configure the value of all register signals of
R2 signaling.
Use the undo register-value command to restore the default value.
Syntax register-value { billingcategory | callcreate-in-groupa |
callingcategory | congestion | demand-refused | digit-end | nullnum |
req-billingcategory | req-callingcategory | req-currentdigit |
req-firstcallingnum | req-firstdigit | req-nextcallednum |
req-nextcallingnum | req-lastfirstdigit | req-lastseconddigit |
req-lastthirddigit | req-switch-groupb | subscriber-busy |
subscriber-idle } value
undo register-value { billingcategory | callcreate-in-groupa |
callingcategory | congestion | demand-refused | digit-end | nullnum |
req-billingcategory | req-callingcategory | req-currentdigit |
req-firstcallingnum | req-firstdigit | req-nextcallednum |
req-nextcallingnum | req-lastfirstdigit | req-lastseconddigit |
req-lastthirddigit | req-switch-bgroup | subscriber-busy |
subscriber-idle }
Parameters billingcategory value
Specifies the billing category value. Valid values are 1
to 16.
If no value is specified, the default is 1.
callcreate-in-groupa value
Specifies the directly created calling signal value. Valid
values are 1 to 16.
If no value is specified, the default is 6.
callingcategory value
Specifies calling category value. Valid values are 1 to
16.
If no value is specified, the default is 1.
congestion value
Specifies congestion value. Valid values are 1 to 16.
If no value is specified, the default is 4.
demand-refused value
Specifies demand-refused value. Valid values are 1 to
16.
If no value is specified, the default is 12.
digit-end value
Specifies digit-end value. Valid values are 1 to 16.
If no value is specified, the default is 15.
nullnum value
Specifies null number value. Valid values are 1 to 16.
If no value is specified, the default is 5.
req-billingcategory value
Specifies request billing category value. Valid values
are1 to 16.
If no value is specified, the default is 3.
req-callingcategory value
Specifies request calling category value. Valid values
arein the range 1 to 16.
If no value is specified, the default is 3.
req-currentdigit value