Command Reference Guide

3Com Router 5000 Family and Router 6000 Family re-answer ● 217
Command Reference
re-answer
Purpose Use the re-answer command to enable or disable the originating point to support
re-answer signal process.
Syntax re-answer { enable | disable }
Parameters enable
Enables the originating point to support re-answer
signal process.
disable
Disables the originating point to support re-answer
signal process.
Default By default, the originating point does not support re-answer signal process.
Example Enable the originating point to process re-answer signals.
[Router-cas1/0/0:0] re-answer enable
View This command can be used in the following views:
■ R2 CAS view
Description Use the re-answer command to enable or disable the originating point to support
re-answer signal process.
This command applies to E1 voice only.
In some countries, re-answer process is needed in R2 signaling. When the terminating
point sends a clear-back signal, the originating point does not release the line right
away, but maintains the call state instead. If it receives the re-answer signal from the
terminating point in the specified time, it continues the call; otherwise, it disconnects
the call after timeout.
Related Commands ■ answer
■ timer dl re-answer