Command Reference Guide

214 ● process-config 3Com Router 5000 Family and Router 6000 Family
Command Reference
process-config
Purpose Use the process-config command to configure the dialing process of a certain
access service number.
Syntax process-config { callernumber | cardnumber | voice-caller }
Parameters callernumber
Caller number process. After a user dials the access
service number, the system continues to send dialing
tones to the user, so that he can enter the called
number. Under this process, the user’s ID is
authenticated by identifying the caller number.
cardnumber
Card number process. After a user dials the access
service number, the system continues to send
prompting tones to the user, so that he can enter the
prepaid card number and password. Under this
process, the user’s ID is authenticated by identifying
the prepaid card number/password.
voice-caller
Voice caller number process. Configured with it, the
system plays voice messages to users after they dial the
access number, asking them to select language and
input the called numbers. In this process, users are
authenticated using calling number identification
(CNI).
When the user changes the current dial process (that
is, between the calling number dial process and the
card number dial process), the system restores the
involved parameters (for example, card number/PIN,
and redial times in the card number process) to the
defaults automatically.
Default By default, all access service numbers use the card number process.
Example Specify the user access process of the access service number 18901 as the card
number process.
[Router-voice-dial-anum18901] process-config cardnumber
View This command can be used in the following views:
■ Voice Access-Number view
Description Each access service number has a specific dialing process. For a certain access service
number, all the users to whom it belongs must implement call establishment in the
same process.