Command Reference Guide

3Com Router 5000 Family and Router 6000 Family private-line ● 213
Command Reference
private-line
Purpose Use the private-line command to configure private auto-ring mode for the
subscriber line and the E.164 telephone number of the destination end.
Use the undo private-line command to cancel the specified connection mode.
Syntax private-line string
undo private-line
Parameters string
E.164 telephone number of the destination end, and it
may include these characters: 0 to 9, *, and #.
Default By default, no private auto-ring mode is configured.
Example Set an automatic dialing to 5559262 after off-hook on the subscriber line 1/0/0.
[Router-voice-line1/0/0] private-line 5559262
View This command can be used in the following views:
■ Voice Subscriber-Line view
Description This command is applicable to FXO, FXS, analog E&M subscriber-lines and digital E1
voice subscriber-line.
The private-line command is used to specify a connection mode for
subscriber-line. The parameter
string will serve as the called number of all the calls
incoming to this subscriber line, i.e., after off-hook, the user need not perform any
operation and the system will dial out the string as the called number automatically.
If the private-line command is not configured, when the subscriber-line enters
an off-hook status, the standard session application program will generate a dial tone
until enough numbers are collected and the call process is completed.