Command Reference Guide

3Com Router 5000 Family and Router 6000 Family password-digit ● 203
Command Reference
password-digit
Purpose Use the password-digit command to configure the user password digits of a
certain access service number in the card number process.
Syntax password-digit password-digit
Parameters password-digit
The password digit, in the range from 1 to 16.By
default, the user password is in 6 digits.
Example Set the password in 4 digits for the access service number 18901.
[Router-voice-dial-anum18901] password-digit 4
View This command can be used in the following views:
■ Voice Access-Number view
Description This command is used to configure the password digit of two-stage dialing card
number process (use the card number/password to authenticate a user’s ID) users.
If the dialing process of the access service number to be configured is not specified as
the card number process through the
process-config command, this command
cannot take effect. Only after the dialing process is set as the card number process,
can the access service number be retrieved, and can this command function properly.
Related Commands ■ gw-access-number
■ process-config
■ card-digit