Command Reference Guide

182 ● line 3Com Router 5000 Family and Router 6000 Family
Command Reference
line
Purpose Use the line command to configure the corresponding relationship between the
POTS voice entity and the logic subscriber line.
Use the
undo line command to cancel the corresponding relationship between the
POTS peer and the logical subscriber line.
This command applies to E1 and T1 voice.
This command can be used in POTS voice entity view only and takes effect on E1/T1
voice subscriber-line only.
Use the command
line e1-number:ts-set-number to select the subscriber line
corresponding to Timeslot set in this E1 subscriber-line as the routing output. Use the
command
line e1-number:15 corresponding to the ISDN PRI set in this E1
subscriber-line as the routing output. Use the command
line t1-number:23
corresponding to the ISDN PRI set in this T1 subscriber-line as the routing end.
Syntax line slot -number { ts-set-number | 15 }
line slot -number : 23
undo line
Parameters slot –number
Indicate the serial number of E1/T1 subscriber-line to
which this subscriber line belongs.
ts-set-number
Indicate the serial number of Timeslot set established
successfully.
15
Indicate adopting the E1 voice ISDN PRI interface
mode.
23
Indicate adopting the T1 voice ISDN PRI interface
mode.
Example Configure the corresponding relationship between POTS voice entity 3 and No.1
Timeslot set in E1 subscriber-line.
[Router-voice-dial-entity3] line 1/0/1:1
View This command can be used in the following views:
■ POTS Voice Entity view
Description After configuring the destination mode of voice entity by using the command
match-template, it is required to use the command line to configure the
corresponding relationship between the POTS voice entity and logic line, that is, to
specify that via which line the routing should be performed toward this destination.