Command Reference Guide

3Com Router 5000 Family and Router 6000 Family line ● 181
Command Reference
line
Purpose Use the line command to associate the voice entity with a specified voice
subscriber-line.
Use the
undo line command to cancel this association.
This command can be used in POTS Voice entity view only.
Syntax line line-number
undo line
Parameters line-number
Number of a subscriber line.
Example Associate voice entity 10 and voice subscriber-line 0/0/0.
[Router-voice-dial-entity10] line 0/0/0
View This command can be used in the following views:
■ POTS Voice Entity view
Description It can take effect only on FXS, FXO, analog E&M, and digital E&M interfaces.
Figure 1 Number the voice subscriber-lines on voice cards
The above figure displays the rear view of a router installed with four voice cards. The
first card provides two subscriber lines, while other three provides four subscriber lines
each. The voice subscriber-line numbers are set according to the card sequence from
the left to the right, and add 1 in order starting from 0.
solt 3
solt 0
sol t 2
slo
t 1
line0/0/0 line0/0/1 line0/0/2 line0/0/3 line1/0/0 line1/0/1