Command Reference Guide

174gw-access-number 3Com Router 5000 Family and Router 6000 Family
Command Reference
gw-access-number
Purpose Use the gw-access-number command to configure the access service number or
enter the view of the access service number.
Use the
undo gw-access-number command to cancel a single access service
number or all access service numbers that have been set.
Syntax gw-access-number access-number
undo gw-access-number [ access-number ]
Parameters access-number
The specified access service number (such as 169,
17900, etc.). The value is a character string within 31
characters, and the acceptable symbols include the
figures from 0 to 9, the wildcard “.”. The “.” wildcard
indicates a character. The character “T" is control
character, it indicating that the dial string is a string
whose length is variable. At most 100 access service
numbers can be configured.
Example Add the access service number 18901 and enter the voice access-number view.
[Router-voice-dial] gw-access-number 18901
[Router-voice-dial-anum18901]
Delete all the access service numbers that have been set in the system.
[Router-voice-dial] undo gw-access-number
View This command can be used in the following views:
Voice Dial Program view
Description If no access service number is specified in the undo gw-access-number command,
all existing access service numbers are deleted. If an access service number is
specified, only this number is deleted.
When you attempt to delete all access service numbers that have been set, the system
gives the following operation warning:
Delete all of the access number? (n/y)
Select “y” to confirm the delete or “n” to cancel the delete.
When setting an access service number, pay attention to the following points:
No unacceptable character is allowed to appear in the access service numbers, if
any of these characters (such as English characters, etc.) appears in the entered
access-number, this enter is invalid.