Command Reference Guide

166 ● force-metering 3Com Router 5000 Family and Router 6000 Family
Command Reference
force-metering
Purpose Use the force-metering command to enable or disable the metering signal of R2
signaling.
Syntax force-metering { enable | disable }
Parameters enable
Enables the metering signal of R2 signaling.
disable
Disables the metering signal of R2 signaling.
Default By default, the metering signal of R2 signaling is disabled.
Example Enable the metering signal of R2 signaling.
[3Com -cas1/0/0:0] force-metering enable
View This command can be used in the following views:
■ R2 CAS view
Description Use the force-metering command to enable or disable the metering signal of R2
signaling.
This command applies to E1 voice only.
If the opposite exchange supports the metering signal, 3Com router, as the
terminating point, sends a forced-release signal instead of a clear-back signal when it
terminates a call, so as to indicate that the called party has release the line and the call
is terminated. And so metering signal collision can be avoided.