Command Reference Guide

164 ● final-callednum 3Com Router 5000 Family and Router 6000 Family
Command Reference
final-callednum
Purpose Use the final-callednum command to enable or disable the terminate signal to
be sent to the terminating point after the called number is sent.
Syntax final-callednum { enable | disable }
Parameters enable
Enables the called number terminate signal to be sent
back.
disable
Disables the called number terminate signal to be sent
back.
Default By default, the called number terminate signal is disabled.
Example Enable the called number terminate signal.
[3Com -cas1/0/0:0] final-callednum enable
View This command can be used in the following views:
■ R2 CAS view
Description Use the final-callednum command to enable or disable the terminate signal to
be sent to the terminating point after the called number is sent.
This command applies to E1 voice only.
In some countries, the R2 interregister signaling can be used to send the called
number terminate signal after the called number is sent out, indicating that the called
number transmission is completed. In this case, you can use this command to adjust
the signaling exchange approach. When the terminating point receives the terminate
signal, it stops requesting for the called number.
Related Command register-value digital-end