Command Reference Guide

3Com Router 5000 Family and Router 6000 Family fax train-mode ● 163
Command Reference
fax train-mode
Purpose Use the fax train-mode command to configure the training mode used by the
gateway.
Use the
undo fax train-mode command to restore the training mode used by
the gateway to the default.
Syntax fax train-mode { local | ppp }
undo fax train-mode
Parameters local
Use the local training mode.
ppp
Use the end-to-end training mode.
Default By default, the ppp mode is adopted.
Example Set the mode used by the gateway as the local training mode.
[Router-voice-dial-entity1] fax train-mode local
View This command can be used in the following views:
■ Voice Entity view
Description The local training mode means that the gateway participates in the rate training
between the facsimile terminals at both ends. In this mode, first carry on the training
between the facsimile terminals and between the gateways respectively, then the
receiving gateway will transmit the training result of the receiving end to the gateway
at the transmitting end. The transmitting gateway will decide the final packet
transmission rate according to the training results of both ends.
The end-to-end training mode means that the gateway does not participates in the
rate training between the facsimile terminals at both ends. In this mode, the rate
training is carried on between the facsimile terminals at both ends, and it is
transparent to the gateway.