Command Reference Guide

3Com Router 5000 Family and Router 6000 Family jitter-packetnum ● 229
Command Reference
jitter-packetnum
Purpose Use the jitter-packetnum command to configure the number of packets to be
sent in a jitter test.
Use the undo jitter-packetnum command to restore the default.
Syntax jitter-packetnum number
undo jitter-packetnum
Parameters number
Number of packets to be sent in a jitter test. The range
of acceptable values depends on whether a voice test
is configured. For a jitter test, valid values are 10 to
1000, defaulting to 10. If voice codec is configured,
valid values are 10 to 60000, defaulting to 1000.
Example Send 30 packets in a jitter test.
[Router-administrator-icmp] jitter-packetnum 30
View This command can be used in the following views:
■ HWPing Test Group view
Description This command applies only to jitter test.
Related Command jitter-interval