Command Reference Guide

3Com Router 5000 Family and Router 6000 Family delay ● 75
Command Reference
delay
Purpose Use the delay command to configure the relevant time parameters on an FXO or
analog E&M subscriber-line.
Use the
undo delay command to restore the default values of these time
parameters.
Syntax delay { dtmf | dtmf-interval } milliseconds
delay start-dial seconds
undo delay { dtmf | dtmf-interval start-dial }
Parameters dtmf milliseconds
Lasting duration of a DTMF signal on the FXO
interface, which is in the range of 50 to 500ms and
defaults to 120ms.
dtmf-interval milliseconds
Interval between two DTMF signals on the FXO
interface, which is in the range of 50 to 500ms and
defaults to 120ms.
start-dial seconds
Delay for dialing on the FXO interface. It ranges from 0
to 10 seconds and defaults to 1 second.
Example Set the maximum hold time for delay on line 1/0/0 to 3000ms.
[Router-voice-line1/0/0] delay hold 3000
View This command can be used in the following views:
■ FXO Voice Subscriber-Line view
Description All the commands listed above are used for configuring the device of a calling party
and hence are only useful for the calling party.
Related Command timer