Command Reference Guide

3Com Router 5000 Family and Router 6000 Family delay ● 73
Command Reference
delay
Purpose Use the delay command to configure the related time parameters at the digital
E&M subscriber-line (E1 controller).
Use the
undo delay command to restore these parameters to the default value.
Syntax delay { call-interval | hold | rising | send-dtmf | dtmf |
dtmf-interval | wink-rising | wink-hold | send-wink | start-dial }
milliseconds
undo delay { call-interval | hold | rising | send-dtmf | dtmf |
dtmf-interval | wink-rising | wink-hold | send-wink | start-dial }
Parameters call-interval milliseconds
The call interval for digital E&M voice subscriber-line, in
the range of 200 to 2000ms. By default, the value is
200ms.
hold milliseconds
The maximum duration the caller will wait for the
callee to hang up so as to send the DTMF number in
analog E&M subscriber-line delay-start mode. It ranges
from 100 to 5000ms, and is defaulted to 400ms.
rising milliseconds
The maximum duration the caller will wait from the
sending of off-hook signal to the callee’s status
detected in analog E&M subscriber-line delay-start
mode. It ranges from 20 to 2000ms, and is defaulted
to 300ms.
send-dtmf milliseconds
The delay before the caller sends signal in analog E&M
subscriber-line immediate-start mode. It ranges from
50 to 5000ms, and is defaulted to 100ms.
dtmf milliseconds
The lasting duration of the DTMF signals in the range
of 50 to 500ms. By default, the value is 120ms.
dtmf-interval milliseconds
The interval between two DTMF signals in the range of
50 to 500ms. By default, the value is 120ms.
wink-rising milliseconds
The maximum duration the caller will wait for the wink
signals after sending the seizure signals in analog E&M
subscriber-line wink-start mode. It ranges from 100 to
5000ms, and is defaulted to 500ms.
wink-hold milliseconds
The maximum lasting duration of the wink signals are
received by the caller in analog E&M subscriber-line
wink-start mode. It ranges from 100 to 3000ms, and is
defaulted to 500ms.
send-wink milliseconds
Specify how long the called party will delay sending
wink signal after receiving the seizure signal on E&M
interface. It ranges from 100 to 5000ms and defaults
to 500ms.
start-dial milliseconds
The delay for dialing. It is in the range of 1 to 10
seconds and defaults to 1 second.