Command Reference Guide

3Com Router 5000 Family and Router 6000 Family debugging voice r2 ● 51
Command Reference
debugging voice r2
Purpose Use the debugging voice r2 command to enable the corresponding debugging
in R2 signaling module.
Use the
debugging voice r2 ccb command to view the information of the
corresponding control block by specifying the E1 port number and time slot number.
This command applies to E1 voice only.
Syntax debugging voice r2 { all | ccb controller slot-number timeslots-list |
dl | dtmf | error | mfc | msg | rcv | warning }
Parameters all
Enables all the debugging in R2 software module.
ccb controller
Enables all the CCB debugging in R2 signaling.
dl
Enables the line signaling debugging in R2 signaling.
dtmf
Enables the Dual-Tone Multifrequency (DTMF)
debugging in R2 signaling.
error
Enables the error debugging in R2 software module.
msg
Enables the message interface debugging in R2
signaling.
mfc
Enables the interregister signaling debugging in R2
signaling.
rcv
Enables the RCV software module debugging in R2
software module.
warning
Enables warning debugging in R2 software module.
slot-number
E1 port number.
timeslots
Time slot number, ranging from 1 to 31.
Example Enable all the line signaling debugging in R2 signaling on E1 voice port.
<Router> debugging voice r2 dl
View This command can be used in the following views:
■ User view