Command Reference Guide

26 ● card-digit 3Com Router 5000 Family and Router 6000 Family
Command Reference
card-digit
Purpose Use the card-digit command to configure the number of digits in a card number
for an access service number.
Syntax card-digit card-digit
Parameters card-digit
The card digits. Valid values are 1 to 31.
If no value is specified, the default user card number is
12 digits.
Example Set the user card number in 10 digits for the access service number 18901.
[Router-voice-dial-anum18901] card-digit 10
View This command can be used in the following views:
■ Voice Access-Number view
Description This command is used to configure digits of the card number of the two-stage dialing
card number process (use the card number/password for ID authentication) user.
Once the digits are specified, all users using this access service number must enter the
card number in specified digits.
If the dialing process of the access service number to be configured is not specified as
the card number process through the process-config command, this command will
not take effect. Only after the dialing process is set as the card number process, can
this command function properly in the Voice access-number view.
Related Command ■ gw-access-number
■ process-config
■ password-digit