Command Reference Guide

3Com Router 5000 Family and Router 6000 Family call-mode ● 25
Command Reference
call-mode
Purpose Use the call-mode command to configure a call-mode for calls between local
router and peer router.
Use the undo call-mode command to restore the default value.
Syntax call-mode { static | dynamic }
undo call-mode [ static | dynamic ]
Parameters static
FRF.11 trunk mode is adopted.
dynamic
Dynamic calling is adopted.
Default By default, the dynamic mode is adopted.
Example Configure static mode for the VoFR voice entity 10.
[Router-voice-dial-entity10] call-mode static
View This command can be used in the following views:
■ Voice Entity view
Description If dynamic is configured in this command, which call signaling should be adopted will
be specified by the
vofr command on the DLCI.
If frf11-trunk is configured in this command, the trunk-id command must be
configured for the VoFR voice entity of the called party.
Related Commands ■ trunk-id
■ address