Command Reference Guide

3Com Router 5000 Family and Router 6000 Family authentication-did ● 19
Command Reference
authentication-did
Purpose Use the authentication-did command to enable authentication for all
one-stage dial (direct dial) users.
Use the undo authentication-did command to disable authentication for
one-stage dial users.
Syntax authentication-did
undo authentication-did
Parameters None
Default By default, authentication is disabled for one-stage dial users.
Example Enable authentication for one-stage dial users.
[Router-voice-aaa] authentication-did
View This command can be used in the following views:
■ Voice AAA view
Description This command is available to one-stage dial (that is, dialing the called number directly)
users but not to two-stage dial (that is, dialing the access service number) users.
After this command is configured, the calling number in a call from a one-stage dial
user is extracted and sent to the RADIUS Server for authentication. Only after passing
authentication can the user obtain services. If the authentication fails, the user is
disconnected and cannot make the IP phone call.
If authentication is disabled for one-stage dial users, one-stage dial users can directly
dial IP phones without being authenticated.
Related Command ■ authentication-did
■ accounting