Command Reference Guide

18 ● authentication 3Com Router 5000 Family and Router 6000 Family
Command Reference
authentication
Purpose Use the authentication command to enable user authentication and
authorization for the access service number.
Use the undo authentication command to disable user authentication and
authorization for the access service number.
Syntax authentication
undo authentication
Parameters None
Default By default, user authentication and authorization is disabled for all access service
numbers.
Example Enable user authentication and authorization for the two-stage dial access service
number 2005.
[Router-voice-dial-anum2005] authentication
View This command can be used in the following views:
■ Voice Access-Number view
Description If user authentication and authorization is enabled for an access service number, the
user who uses this access service number can be authorized and dial the IP phone
only after it has been authenticated.
If user authentication and authorization is disabled, the user who uses this access
service number can directly dial the IP phone without being authenticated.
Related Commands ■ gw-access-number
■ accounting optional
■ authentication-did