Command Reference Guide

14 ● answer 3Com Router 5000 Family and Router 6000 Family
Command Reference
answer
Purpose Use the answer command to configure whether the terminating point is required to
send answer signal.
Syntax answer { enable | disable }
Parameters enable
The originating points requires that the terminating
point must send answer signal. Only after the
originating point receives the signal, can the peers
enter the communicating state.
disable
The originating point does not require the terminating
point to send answer signal. In case the terminating
point does not send answer signal, the originating
point automatically report the answer message to the
upper layer when the timer times out to have the peers
enter the communicating state.
Default By default, the terminating point is required to send answer signal.
Example Disable the terminating point to send answer signals.
[Router-cas1/0/0:0] answer disable
View This command can be used in the following views:
■ R2 CAS view
Description Use the answer command to configure whether the terminating point is required to
send answer signal.
This command applies to E1 voice only.
In some countries, answer signals are not sent in the R2 line signaling coding scheme.
In this case, you can use the
answer command to adjust this signaling coding
scheme. If the originating point does not require answer signals, the terminating
point confirms call connection after the specified time.
Related Commands ■ re-answer
■ timer dl re-answer