Command Reference Guide

3Com Router 5000 Family and Router 6000 Family ani-offset ● 13
Command Reference
ani-offset
Purpose Use the ani-offset command to configure the number of digits of the called
number to be collected prior to requesting the calling party information.
Use the undo ani-offset command to restore the default value.
Syntax ani-offset number
undo ani-offset
Parameters number
The number quantity collected. Valid values are an
integer from 1 to10.
If no value is specified, the default value of number is
1.
Example Set to start requesting the caller number or caller identifier after receiving the 3-digit
numbers.
[Router-cas1/0/0:0] ani-offset 3
View This command can be used in the following views:
■ R2 CAS view
Description Use the ani-offset command to configure the number of digits of the called
number to be collected prior to requesting the calling party information.
Use the undo ani-offset command to restore the default value.
This command applies to E1 voice only.
This command is used for setting the number of digits of the called number to be
collected prior to requesting the caller number or caller identifier. When the quantity
of the collected numbers is less than this value, the system will wait to the next
number till timeout, and in the waiting it will not request the caller number
information from the remote end. When the quantity of the collected numbers is
equal to or exceeds this value, it is able to request the caller number or caller identifier
from the remote end.
Related Commands ■ cas
■ timer
■ reverse
■ renew