Command Reference Guide

12 ● ani 3Com Router 5000 Family and Router 6000 Family
Command Reference
ani
Purpose Use the ani command to enable or disable the terminating point to send the calling
party information (service category and calling number) to the originating point
during call connecting process.
Use the undo ani command to cancel the above configuration.
Syntax ani { all | ka }
undo ani
Parameters all
Requires the remote end to send the category of the
calling party and calling number.
ka
Requires the remote end to send the category of the
calling party only.
Default By default, the terminating point does not send the calling party information to the
originating point.
Example Configure that the local exchange requests the opposite exchange to send the
category of the calling party and calling number during the connecting process.
[Router-cas1/0/0:0] ani all
View This command can be used in the following views:
■ R2 CAS view
Description ■ Configure the local end with this command to support automatic number
identification.
■ This command applies to E1 voice only.
■ Normally the all keyword is configured. To prevent call failures, use the ka keyword
only when required by the connected switch.
Related Commands ■ cas
■ ani-offset