Command Reference Guide

10 ● address 3Com Router 5000 Family and Router 6000 Family
Command Reference
address
Purpose Use the address command to configure the voice routing policy to the peer voice
gateway.
Use the undo address command to cancel the voice routing policy that has been
configured.
Syntax address { ip ip-address | ras }
undo address { ip | ras }
Parameters ip ip-address
Indicates a VoIP dial entity session destination, that is,
the called IP address.
ras
Router uses RAS recommendation to interact
information with GK Server to map the called phone
number to the IP address of peer voice gateway. It is
used only in the networking configuration that uses
GK (gatekeeper) to provide voice IP services.
Default By default, no routing policy is configured.
Example Configure the destination IP address corresponding to the called 12345 as 10.1.1.2.
[Router-voice-dial-entity1] match-template 12345
[Router-voice-dial-entity1] address ip 10.1.1.2
View This command can be used in the following views:
■ Voice Entity view
Description This command is used to configure the network address for the VolP voice entity. The
system supports the following two VolP routing policies at present.
■ Static routing policy: Find the IP address of destination voice gateway in static
mode according to address ip ip-address command.
■ Dynamic routing policy: The router and GK Server interact with RAS information
after the
address ras command is configured. GK will dynamically send back
the peer voice gateway address that matches the called number to the router.
Related Commands ■ address sip
■ match-template