Command Reference Guide

8 ● address 3Com Router 5000 Family and Router 6000 Family
Command Reference
address
Purpose Use the address command to configure a route to the peer voice gateway or assign
an X.121 address for a destination host.
Use the undo address command to cancel the setting.
Syntax address { vofr-dynamic serial interface-number dlci-number | x121
x121-address }
undo address { vofr-dynamic [ x121 }
Parameters vofr-dynamic serial
interface-number
Session target interface of a VoFR voice entity.
dlci-number
Session target DLCI of a VoFR voice entity. Valid values
are 16 to 1007.
x121 x121-address
X.121 address of destination host. By default, the
X.121 address is null.
Default By default, no route to the peer voice gateway is configured.
Example Set the X.121 address of the destination host to 10001.
[Router-voice-dial-entity4] address x121 10001
Assign 100 to the DLCI for the session target Serial 1/0/0 corresponding to the called
number 12345.
[Router-voice-dial-entity4] match-template 12345
[Router-voice-dial-entity4] address vofr-dynamic serial1/0/0 100
View This command can be used in the following views:
■ Voice Entity view
Description The X.121 address configured in this command must be the same X.121 address used
by the destination host.
Configuring the address of VoFR voice entity in switch mode includes configuring
output interface and outgoing DLCI number. Configuring the session target of VoFR
voice entity in FRF.11 trunk mode includes configuring output interface, outgoing
DLCI number, FRF.11 subchannel number and creating voice channel without delay.
Voice channel is deleted when deleting the address.