Command Reference Guide

48 ● standby routing-group 3Com Router 5000 Family and Router 6000 Family
Command Reference
standby routing-group
Purpose Use the standby routing-group command to apply a dynamic routing standby
group on the secondary interface.
Use the undo standby routing-group command to remove the dynamic
routing standby group from the dialer interface.
Syntax standby routing-group group-number
undo standby routing-group group-number
Parameters group-number
Number of the dynamic routing standby group. Valid
values are 1 to 255.
Example Apply dynamic routing standby group 1 on the interface BRI 0/0/0.
[3Com -Bri0/0/0] standby routing-group 1
Remove dynamic routing standby group 1 from the interface BRI 0/0/0.
[3Com -Bri0/0/0] undo standby routing-group 1
View This command can be used in the following views:
■ Dial Interface view
Description Before applying a dynamic routing standby group on the interface, make sure you
have successfully configured the legacy DCC.