Command Reference Guide

34 ● interface dialer 3Com Router 5000 Family and Router 6000 Family
Command Reference
interface dialer
Purpose Use the interface dialer command to create a dialer circular group for the
Circular DCC, or configure a dialer interface for the Resource-Shared DCC.
Use the undo interface dialer command to cancel the existing setting.
Syntax interface dialer number
undo interface dialer number
Parameters number
Interface number. The range of valid values varies with
router model.
Default By default, no dialer interface is defined.
Example Define a dialer interface dialer 1.
[3Com ] interface dialer 1
View This command can be used in the following views:
■ System view
Description In Resource-Shared DCC, any dialer interface can use the services provided by
multiple physical interfaces, and individual physical interfaces can provide services for
multiple dialer interfaces at the same time. Therefore, authentication must be
configured on these physical interfaces, so as to use the user name of a dial-in party
to locate the corresponding dialer interface for the call. In this mode, physical
interfaces and dialer interfaces are dynamically bound. Furthermore, a dialer interface
can only call a destination address, which will be specified in the
dialer number
command.
The physical interfaces in Circular DCC and Resource-Shared DCC do not use
individual network addresses. Instead, they use the addresses of the corresponding
dialer interfaces.