Command Reference Guide

28 ● dialer timer wait-carrier 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer timer wait-carrier
Purpose Use the dialer timer wait-carrier command to configure the timeout time
of wait-carrier timer.
Use the undo dialer timer wait-carrier command to restore the default
time of the timer.
Syntax dialer timer wait-carrier seconds
undo dialer timer wait-carrier
Parameters seconds
Waiting time in seconds. Valid values are 0 to 65535.
If no value is specified, the default time waiting for a
call connection is 60 seconds.
Example Set the maximum duration of the time that Serial 0/0/0 waits for call to establish to be
100 seconds.
[3Com -Serial0/0/0] dialer timer wait-carrier 100
View This command can be used in the following views:
■ Physical or Dialer Interface view
Description Wait-carrier timer begins to time after the DCC call is initiated. If the call connection
fails to be set up within the timeout time of this timer, the call will be terminated.
If the connection for a call is not established yet within the specified time, DCC will
terminate the call.