Command Reference Guide

26 ● dialer timer enable 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer timer enable
Purpose Use the dialer timer enable command to configure an interval for the next call
attempt on an interface after the link is disconnected.
Use the undo dialer timer enable command to restore the default interval.
Syntax dialer timer enable seconds
undo dialer timer enable
Parameters seconds
Interval for originating the next call (in seconds). Valid
values are 5 to 65535.
If not specified, the default interval is 5 seconds.
Example Set the interval for DCC to make the next call attempt to 15 seconds.
[3Com -Serial0/0/0] dialer timer enable 15
View This command can be used in the following views:
■ Physical or Dialer Interface view