Command Reference Guide

24 ● dialer timer autodial 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer timer autodial
Purpose Use the dialer timer autodial command to configure the automatic dialing
interval of DCC.
Use the undo dialer timer autodial command to resume the default
interval.
Syntax dialer timer autodial seconds
undo dialer timer autodial
Parameters seconds
Interval before the next call attempt (in seconds). Valid
values are 1 to 604800.
If not specified, the default interval is 300 seconds.
Example Set the DCC automatic calling interval on Serial0/0/0 to 60 seconds.
[3Com -Serial0/0/0] dialer timer autodial 60
View This command can be used in the following views:
■ Physical or Dialer Interface view
Description This command should be used together with the auto-dial keyword in the dialer
route
command. DCC will automatically attempt to dial at intervals of seconds
until the connection is established. The automatic dialing function is independent of
the trigger with data packets and the established connection will not be automatically
cut for timeout. That is, the configuration of the
dialer timer idle command
does not affect it.
Related Command dialer route