Command Reference Guide

14 ● dialer number 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer number
Purpose Use the dialer number command to configure a dial number for placing a call to a
single remote end.
Use the undo dialer number command to cancel the configured dial number.
Syntax dialer number dial-number
undo dialer number
Parameters dial-number
Dial number for calling.
Default By default, no dial number is set for calling the remote end.
Example Set the dialer number for dialer1 calling the remote end to “11111”.
[3Com ] interface dialer 1
[3Com -Dialer1] dialer number 11111
View This command can be used in the following views:
■ Physical or Dialer Interface view
Description This command is used when the dialer interface of Circular DCC serves as caller end
and the dialer originates calls to only one destination address or the default address.
This command is only valid after at least one of the following requirements is
satisfied:
■ The dialer route command is not configured on the interface.
■ The next hop address that sends packets cannot be found in the corresponding
dialer route command.
When dialer interfaces of Resource-Shared DCC run link protocol of PPP, the remote
user names, which are obtained via PPP authentication and configured with dialer
user respectively, will decide which dialer interface will receive the incoming call. In
this case, dialer user must be configured, and dialer number can be configured
optionally.
When dialer interfaces run link protocol of Frame Relay, the calling numbers, which
are received from the incoming call and configured with dialer number respectively,
will decide which dialer interface will receive the incoming call. In this case, dialer
number must be configured, and dialer user can be configured optionally.
Note:
■ If dialer-group command is not configured, DCC will not dial even if dialer
number
command is configured.