Command Reference Guide

12 ● dialer group 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer group
Purpose Use the dialer-group command to configure access control on the packets
transmitted on a DCC interface and to place the interface in an access control group.
Use the undo dialer-group command to cancel the interface from united with
the access control group.
Syntax dialer-group group-number
undo dialer-group
Parameters group-number
Sequence number of the dialer access number. Valid
values are 1 to 255. This group is set through the
dialer-rule command.
Default By default, this command is not configured.
Example Add Serial1/0/0 interface to dialer-group 1.
[3Com ] dialer-rule 1 acl 3101
[3Com ] interface serial1/0/0
[3Com -Serial1/0/0] dialer-group
View This command can be used in the following views:
■ Physical or Dialer Interface view
Description This command is used for associating a physical interface with an access control
group. Through the
dialer-rule command, the user can associate an access
control group with the
acl command. A DCC interface can only be the member of
an access control group. If it is configured to be a member of another access control
group, this configuration will replace the previous one.
In the default configuration of the interface, dialer-group is not configured. The
user must configure this command. Otherwise, DCC will be unable to transmit
packets.
Related Command dialer-rule