Command Reference Guide

3Com Router 5000 Family and Router 6000 Family dialer enable-circular ● 11
Command Reference
dialer enable-circular
Purpose Use the dialer enable-circular command to enable Circular DCC.
Use the undo dialer enable-circular command to disable Circular DCC.
Syntax dialer enable-circular
undo dialer enable-circular
Parameters None
Default By default, Circular DCC is enabled on the ISDN interfaces and disabled on other
interfaces.
Example Enable Circular DCC on Serial 0/0/0.
[3Com -Serial0/0/0] dialer enable-circular
View This command can be used in the following views:
■ Physical or Dialer Interface view
Description The user must use this command to enable it before using Circular DCC.
Related Command dialer circular-group