Command Reference Guide

6 ● dialer bundle-member 3Com Router 5000 Family and Router 6000 Family
Command Reference
dialer bundle-member
Purpose Use the dialer bundle-member command to configure a physical interface
included in a dialer bundle in the Resource-Shared DCC application.
Use the undo dialer bundle-member command to remove the physical
interface from the dialer bundle.
Syntax dialer bundle-member number [ priority priority | max-link max-num |
min-link min-num]
undo dialer bundle-member number
Parameters number
Dialer bundle number ranging from 1 to 255.
priority
Priority of the physical interface in the dialer bundle,
ranges from 1 to 255. The physical interface with
higher priority will be used first. This is an optional
parameter. By default, priority is 1.
max-num
The maximum number of channels that can be used.
min-num
The minimum number of channels that can be used.
Default By default, the physical interface is not assigned to any dialer bundle.
Example Make Bri1/0/0 a member of dialer bundle1 and dialer bundle2, and assigns it a
priority of 50.
[3Com ] interface bri 1/0/0
[3Com -Bri1/0/0] dialer bundle-member 1 priority 50
[3Com -Bri1/0/0] dialer bundle-member 2 priority 50
View This command can be used in the following views:
■ Physical Interface view
Description This command can only be applied to a physical interface, which can be assigned to
multiple dialer bundles.
To enable the B channel of ISDN interface (BRI or PRI) to configure its link layer
protocol dynamically in terms of the Dialer interface it belongs to, link layer protocol
that the interface uses should be specified as PPP.
Related Command dialer bundle