Command Reference Guide

22 ● vrrp vrid virtual-ip 3Com Router 5000 Family and Router 6000 Family
Command Reference
vrrp vrid virtual-ip
Purpose Use the vrrp vrid virtual-ip command to create a standby group the first
time that you add a virtual IP address or add a virtual IP address to it after that. Each
standby group can accommodate up to 16 virtual IP addresses.
Use the undo vrrp vrid virtual-ip virtual-router-ID command to
remove a standby group.
Use the undo vrrp vrid virtual-router-ID virtual-ip
virtual-address
command to delete a virtual IP address from the specified
standby group.
Syntax vrrp vrid virtual-router-ID virtual-ip virtual-address
undo vrrp vrid virtual-router-ID virtual-ip [ virtual-address ]
Parameters virtual-router-ID
VRRP standby group number. Valid values are 1 to 255.
virtual-address
Virtual IP address.
Default By default, no standby group exists.
Example Create a standby group.
[3Com -Ethernet0/2/0] vrrp vrid 1 virtual-ip 10.10.10.10
Add a virtual IP address to the existing standby group.
[3Com -Ethernet0/2/0] vrrp vrid 1 virtual-ip 10.10.10.11
Delete a virtual IP address.
[3Com -Ethernet0/2/0] undo vrrp vrid 1 virtual-ip 10.10.10.10
View This command can be used in the following views:
■ Ethernet Interface view
■ Bridge Template view
Description The system removes a standby group after you delete all the virtual IP addresses in it.
If there is non-Ethernet interface in a bridge set, then VRRP is not allowed to be
configured on the bridge template corresponding to that bridge set.