Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display vrrp ● 9
Command Reference
display vrrp
Purpose Use the display vrrp command to view current configuration and state
information about VRRP.
Syntax display vrrp [ interface interface-name [ virtual-router-ID ] ]
Parameters interface-name
Specifies an interface by its name. The type of the
interface must be Ethernet.
virtual-router-ID
Standby group number.
Example Display information about all standby groups on the router.
<3Com > display vrrp
Virtual Ip Ping : Disable
Ethernet1/0/0 | Virtual Router 1
state : Initialize
Virtual IP : 22.2.2.2
Virtual MAC : 0000-5e00-0101
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
GigabitEthernet0/1/0 | Virtual Router 1
state : Initialize
Virtual IP : 1.1.11.1
Virtual MAC : 0000-5e00-0102
Config Priority : 100
Run Priority : 100
Preempt : YES Delay Time : 0
Timer : 1
Auth Type : NONE
View This command can be used in the following views:
■ Any view
Description If the interface name and standby group number are not specified, the state
information about all the standby groups on the router is displayed. If the interface
name is specified, the state information about all the standby groups on the interface
is displayed. If both arguments are specified, the status information about the
specified standby group is displayed.