Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display standby state ● 7
Command Reference
display standby state
Purpose Use the display standby state command to view information about the main
and standby interfaces.
Syntax display standby state
Parameters None
Example Set Serial 1/0/0, Serial 0/0/0 and Logic-channel 0 to back up Serial 3/0/0, and
configure backup load sharing on Serial 3/0/0.
[3Com ] interface Serial3/0/0
[3Com -Serial3/0/0] standby interface serial1/0/0 10
[3Com -Serial3/0/0] standby interface serial0/0/0 30
[3Com -Serial3/0/0] standby interface logic-channel0
[3Com -Serial3/0/0] standby threshold 80 50
Display information about the main and standby interfaces.
[3Com -Serial3/0/0] display standby state
Interface Interfacestate Standbystate Standbyflag Pri
Loadstate
Serial2/1 DOWN MDOWN MU
Serial2/3 DOWN DOWN BU 0
Virtual-Ethernet1 DOWN MDOWN MU
Serial2/0 DOWN DOWN BU 0
Standby-flag meaning:
M---MAIN S---Standby V---MOVED U---USED
D---LOAD P---PULLED G---LOGICCHANNEL
View This command can be used in the following views:
■ Any view
Description The following table describes the information that the command provides and the
possible values.